• with DCC Decoder
• with Sound

Road Number Specific ScaleTrains New paint scheme Era: 1966 to early 1970s Santa Fe Series 1830-1889; built 10-12:66, Phase Ib1 Fully-assembled Multiple road numbers LED-illuminated ground lights on both sides of locomotive* LED-Illuminated rectangular walkway lights mounted between front and rear sanding valve doors and round walkway light, aft of raised walkway duct* LED-lit tricolor (red, green, and white) flush-mounted class lights with raised gasket** Front and rear full-width MU catch trays with footboards Front and rear early small deck extension Pivoting front and rear drop steps “Short” stepwells with see-through steps “Early” (“X”) pattern walkway treadplate Latched battery box doors with narrow louvers Latched cab sub-base doors with early hinges 81” low short hood with plated-over handbrake location Standard EMD high headlight in numberboard housing Early straight grabs and “flipped” nut-bolt-washer (NBW) mounting on nose front and top “35-Line” cab with standard front windshields Small mirrors mounted fore of cab side windows on both sides of cab No sunshades No Arm rests No cab vents Lost-wax brass Leslie RS-3L-R three-chime horn; mounted center rear of number board housing Can type antenna mounted on dust bin Standard electrical cabinet seam and bolted alternator door No ECAFB Early (smooth) blower duct housing Standard-height dust bin Standard-height exhaust stack Early (short forward taper) extended-range dynamic brakes “Chickenwire” radiator intake grilles with diamond-pattern mesh screens Standard-height fan housings Photoetched spiral-ring grilles with center disk Long walkway duct with three short stanchions Front and rear straight uncoupling levers with four brackets Handrail set with pilot face mounted outer end rail stanchions 4-hose MU hose clusters with silver gladhands Early (angled) deck-mounted MU receptacle Short “nub-bottom” pilot face Pilot face bracing detail behind stepwells Pilot face grab iron with inner mounting points Tall jacking pads with holes Sill-mount EFCO button Frame-mounted bell Salem air filter (accordion style) 4,000-gallon fuel tank with single fuel filler, single vertical fuel gauge, and round dial fuel gauge per side Detailed Flexicoil-C (low-mount brake cylinder) trucks with Hyatt bearing caps and sanding lines and brackets Speed recorder second axle, left side Factory-applied wire grab irons, wire lift rings, windshield wipers, trainline hoses with silver gladhands, sand hatch covers, and much more Motor with 5-pole skew wound armature Dual flywheels All-wheel drive All-wheel electrical pick-up Directional LED headlights Printing and lettering legible even under magnification Operates on Code 70, 83 and 100 rail Packaging safely stores model Minimum radius: 18” Recommended radius: 22” DCC & sound equipped locomotives also feature: ESU LokSound 5 DCC & Sound decoder with “Full Throttle” functions Two (2) cube-type speakers Turbocharged EMD 20 Cylinder 645E3 prime mover ESU designed “PowerPack” with two super capacitors*** Operates on both DC and DCC layouts