• 與DCC的使用（DCC接口）

New road name Era: 1963 to 1965 Series 750 to 759; built 2/63 Fully-assembled Multiple road numbers Operating LED-illuminated ground lights on both sides of locomotive* Operating LED-illuminated “hemisphere” walkway lights on hood ends, and at end of raised walkway duct* Operating front and rear LED Pyle-National 20585 (Translite) “Gyralite” signal light* Operating front and rear Pyle-National Single Red Gyralite (“UDE Light”)* Operating LED-illuminated tricolor front and rear flush-mounted class lights with lenses and raised gaskets** Cab number boards and hinged rear number indicator housings Front and rear multiple unit (MU) hose catch boxes with footboards 4-hose multiple unit (MU) hose clusters with silver gladhands Semi-scale coupler buffer equipped with durable metal semi-scale Type E knuckle couplers Front and rear straight uncoupling levers without loop handles As-delivered pilot faces without uncoupling lever loop notches Deck-mounted multiple unit (MU) receptacle “Short” stepwells with see-through steps Handrail set with center gangway chains Front and rear standard drop steps Scale sectioned tread plate detail with EMD early “X” style pattern Stepwell/walkway gussets 81” GP30 low short hood with ratchet handbrake and square sand fill Hinged battery box doors with early hinges and narrow louvers Early cab sub-base doors with early hinges Front standard EMD LED-illuminated headlight with lenses on number board housing GP30 cab with increased length on left (fireman’s) side and inverted cab heater vents Detailed cab interior with separate floor, rear wall, seats, and standard AAR control stand No cab vents Sliding cab side windows Tall clear wind wings with mirror at bottom mounted fore of cab side window on both sides of cab SP/SSW sun awning Lost-wax brass cast Nathan P-3 (P24R1 configuration) horn mounted on right side cab eave Motorola ASP-16 “Firecracker” antenna mounted on the cab roof Accurate hood door and long hood detail Late single-panel inertial compartment Wire inertial air intake grills Tall turbo exhaust stack Standard-range dynamic brakes with 48” fan Early See-through dynamic brake intake grills with horizontal wires on top of vertical vanes 6-horizontal rib radiator intake grills See-through front and rear 48” radiator fan housings with 8-blade fans; 36” pan-top center radiator fan Curved radiator fan grab iron Square sand fill hatch on top of long hood end Rear LED-illuminated horizontal headlight with lenses Underbody frame rail with separate plumbing Detailed Blomberg-B trucks with Hyatt bearing housings; elliptical springs; end transom detail; separate sanding lines and brackets; and separate swing hanger detail Dimensionally accurate truck centers Speed recorder mounted to second axle on right front truck sideframe Cab-roof mounted “tripod” bronze bell with air line Prime air filter (can style) 2,600-gallon fuel tank with vertical gauges and fuel fill in sill skirt; round gauges in fuel tank sides Factory-applied wire grab irons, photo etched lift rings, windshield wipers, trainline hoses with silver gladhands, air tanks, sand hatch covers and more Motor with 5-pole skew wound armature Dual flywheels All-wheel drive All-wheel electrical pick-up Directional LED-illuminated headlights Printing and lettering legible even under magnification Operates on Code 70, 83 and 100 rail Packaging safely stores model Minimum radius: 18” Recommended radius: 22”